Hi,
This bottom marked table spoon with an indistinct date letter, has a makers mark I am struggling to identify. Does anybody have any ideas, or is it one of the lost register marks?
Many Thanks
Martin
Trying to id this spoon maker
-
- contributor
- Posts: 407
- Joined: Wed Aug 12, 2015 12:17 pm
Re: Trying to id this spoon maker
Hi Martin,
That to me, looks like a very nice Exeter spoon.
Sorry, I can't help with the maker but I'll move it to the Exeter section to see if we have any luck there.
Trev.
That to me, looks like a very nice Exeter spoon.
Sorry, I can't help with the maker but I'll move it to the Exeter section to see if we have any luck there.
Trev.
-
- contributor
- Posts: 407
- Joined: Wed Aug 12, 2015 12:17 pm
Re: Trying to id this spoon maker
Hi Trev,
Of course you are correct, what I mistook for a date mark is definitely a rubbed Exeter Town Mark, now I just need to track down the maker.
Martin
Of course you are correct, what I mistook for a date mark is definitely a rubbed Exeter Town Mark, now I just need to track down the maker.
Martin
-
- co-admin
- Posts: 1800
- Joined: Tue Apr 09, 2013 9:22 am
- Location: Hertfordshire, UK
- Contact:
Re: Trying to id this spoon maker
This is a mark of Richard Freeman of Plymouth who was working from 1702 to 1753. There is no obvious date letter but it must be later than 1720 as the spoon is sterling standard rather than Britannia standard.
Phil
Phil
-
- contributor
- Posts: 407
- Joined: Wed Aug 12, 2015 12:17 pm
Re: Trying to id this spoon maker
Thanks Phil, I haven't seen this mark of Freeman's before. There are initials and a date of 1743 engraved to the terminal which would seem to fit nicely with the age of the spoon.
Martin
Martin
Re: Trying to id this spoon maker
It looks like one of those cases where a Hanoverian spoon has had the stem cut and resoldered the other way round to make it Old English pattern. The stem seems to have some file marks around where the date letter should be.
Miles
Miles
-
- contributor
- Posts: 407
- Joined: Wed Aug 12, 2015 12:17 pm
Re: Trying to id this spoon maker
Hi Miles, after further inspection I think you are absolutely right, well spotted.
Martin
Martin