Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
Hi,
Millesimal fineness .900, meaning very late 19th century or 2oth century.
Lack of complex marking systems can eliminate several countries e.g. Britain, France.
Lack of characteristic official state marks can eliminate many countries i.e. Spain, Netherlands,Austria.
Likely Germany or Italy and rather newer production.
Unless similar item with the same maker`s mark is found with more specific marks, country of origin would be impossible to identify.
Regards
Somehow the appearance of the dancing couple (dresses etc.) reminds me of Hungary or thereabouts. The watchers on the other hand wear 18th century Western European clothing. Of course this doesn't necessarily tell where the item was made and it's definitely not from the 18th century.
AG2012 wrote:Hi,
Millesimal fineness .900, meaning very late 19th century or 2oth century.
Lack of complex marking systems can eliminate several countries e.g. Britain, France.
Lack of characteristic official state marks can eliminate many countries i.e. Spain, Netherlands,Austria.
Likely Germany or Italy and rather newer production.
Unless similar item with the same maker`s mark is found with more specific marks, country of origin would be impossible to identify.
Regards
You mentioned “.900”, but I see “800” in the marking. Am I looking at this wrong?
Not much difference 800 or 900.
Higher percentage of silver has better casting properties with lost wax technique, but for enamelling there is no difference, really.
Regards
Sometimes the enamel was not applied directly to the box but painted on a separate sheet of silver, fired and then attached to the box.
Anyway,it can be easily tested with the tip of a needle.As enamel is actually molten glass the needle cannot scratch it, so, no harm done.
Under 10X magnification one can easily distinguish brush strokes in hand painted enamel from dots in transfer printing.
Regards
Hi Ag
I have not heard of that method applying a finished enamel section on to a case like this,because of the stress on the enamel base during firing if the base is to thin,and then risking some more damage to the enamel attaching it to the case(by what method soldering or some sort of adhesive )causing more problems, it would not make sense to me to do it that way.
As you say looking at it with an eye glass will give you the answer .
As I said it looks like a watercolour on paper to me or a print of the painting.
Regards Guido.